JWIN JD-VD520 Manuel d'utilisateur télécharger pdf (Page 6)

HOME DVD PLAYER V10M10_IM_EN_12312007

www.jWIN.com

GETTING STARTED

Installing the Remote Control

Batteries

1. Open the battery compartment cover on

the back of the remote control.

2. Place one CR2025 battery as shown on

the picture above. Make sure that the

polarity (+/–) of battery matches the

marks inside the battery compartment.

3. Close the battery compartment.

Notes on Using the Remote Control

Please note that a remote control should be

pointed directly at the remote control sensor

to get the better performance.

Notes on Remote Control

1. Improper use of batteries may cause the battery leakage and corrosion. To operate the

remote control correctly, follow the instructions below:

a. Do not insert the batteries in the wrong direction.

b. Do not attempt to recharge, short-circuit, disassemble, heat or throw the

batteries into a fire.

c. Do not leave the dead batteries in the remote control.

d. If you do not use the remote control for a long period of time, remove the

installed batteries from the remote control to avoid possible damage from the

battery corrosion. If battery leakage occurs, clean the battery compartment and

then insert the new batteries. Please follow the general safety and handling

instructions listed by the battery manufacturer. After cleaning, wash your hand.

2. Do not leave the remote control in an extremely hot or humid place.

3. Do not spill water or put any liquid on the remote control.

4. Do not expose the remote control sensor of the DVD player to a strong light source, such

as direct sunlight.

5. The battery life is approximately one year under the normal working condition. However, it

significantly depends on the battery type and its working condition. If the remote control

doesn’t work or the signal gets weaker, replace the battery. The alkaline batteries are

recommended for the longer battery life.

HOME DVD PLAYER V10M10_IM_EN_12312007

www.jWIN.com

GETTING STARTED

Brief Instructions on Installing the DVD Player

1. Locate the place where you want to install this unit.

2. Refer to the quick connection guides starting on the following page to connect this unit to

other audio or display devices. While installing this unit to other devices, the power cord of

all devices in the installation process should be properly disconnected for the safety

purpose.

3. Connect the power cord of all devices again. Before connecting the power cords, please

carefully follow the safety instructions in the section of the user safety guide.

4. After connecting the power cords, turn on this unit and all the attached devices.

5. Before operating this unit, set the system settings of this unit and all the attached devices

based on your choice of the connection. To properly show the video and audio contents,

this unit and all the attached devices must be set with the correct system settings

accordingly based on your choice of the connection. For this unit, refer to the detailed

system setup instructions in this user’s manual. For the attached devices, refer to the

detailed system setup instructions in their user’s manuals respectively.

Special Notes

1. If this unit is not going to be used for a long period of time, please disconnect the power

cord plug from the outlet.

2. This unit must be operated with the correct power supply corresponding to the marking

label on the back of the unit.

3. This unit may not be compatible with some specially encrypted discs.

Connecting the DVD Player to a TV Set using Audio and Video Cables

Use the Audio cable (Red / White) and Video cable (Yellow) to connect the DVD player to your

TV.

1. Connect the Left and Right audio cables to the front left and front right AUDIO OUT jacks

at the rear of the DVD player. Connect the other ends to the Left and Right IN jacks on the

TV.

2. Connect the video cable.

• For basic video

connection, connect the

VIDEO cable to the

VIDEO OUT jack at the

rear of the DVD player

and the other end to the

VIDEO IN jack on the TV.

1 2 3 4 5 6 7 8 9 10 11 12

Commentaires sur ces manuels

Pas de commentaire

JWIN JD-VD520 Manuel d'utilisateur Page 6

Commentaires sur ces manuels

Produits connexes et manuels pour Lecteurs de DVD JWIN JD-VD520